Sony Glasstron PLM-S700 Mode D'emploi page 31

3
Follow the instructions on the screen.
1 Warning message n Follow steps 3 through 7 in "Checking the display unit
position" (pages 23 through 25).
• After carefully reading the warnings and checking the display unit position, press
the jog dial.
2 Screen alignment n Follow steps 1 through 3 in "Checking the screen position
alignment" (pages 25 through 27).
• Read the warning carefully, and press the jog dial.
• Make sure the left and right screens are aligned, and press the jog dial.
4
Select the input signal using the PC-VIDEO switch.
Select PC (RGB signal) or VIDEO (video
signal) depending on the connected
equipment.
When you connect to the S-video
connector
"S VIDEO" appears on the screen.
5
Input the signal from the connected equipment.
When you connect the PC:
Adjust the screen resolution. For details, see "Signal compatibility" on page 35.
When you display VGA pictures (640 × 480), the picture appears about 60% of the entire
screen.
Notes
• If no picture appears, check the default setting of your PC to output the external RGB signal
from the monitor connector.
• Some PCs do not output external display signal when they turn on, or switch to external
display mode. Change the display mode of your PC, referring to the instruction manual
supplied with your PC.
When you connect the video equipment:
Start playback on the video equipment connected to the Glasstron.
When you display NTSC video picture, the picture appears about 60% of the entire
screen.
PC VIDEO
When you select PC (PC mode)
PC / RGB
When you select VIDEO
(Video mode)
VIDEO
continued
31
-US