EUROM 335491 Manuel D'utilisation page 19

Installation
 Remove all package material and keep the package material away from children.
 Check the appliance, supply cord and the plug for signs of damage.
 Check that all necessary fastenings material are included.
 Check whether the delivered mounting materials are appropriate, strong enough and
suitable for the surface. The delivered materials are intended for a brick surface; for
mounting on a different type of surface, you should consult a specialist dealer for the
appropriate materials.
 Carefully choose the right spot for installing your infrared heater. The appliance must
be mounted on a non-flammable surface. Furthermore, the surface must be free of
vibrations, completely vertical and strong enough to support the appliance in the long
term without any problems.
 Before mounting, check whether the spot you have chosen complies with the minimum
safety distances from the environment. The distance between the bottom side of the
heater and the floor must be at least 1.8 metre. The distance between the top side of
the heater and the ceiling, roof, etc. must be at least 0.3 metre. However, if the ceiling
or roof is made of flammable material (e.g., canvas), then the minimum distance is 1
metre. On both sides of the appliance, the minimum distance to walls, etc. must be 0.5
metre. If you mount the appliance outdoors, then make sure that it is not situated
where it gets direct wind.
Ceiling or wall mounting
 Drill two (2) holes in the ceiling or the wall
according to the measurements shown in the
illustration above. Insert two (2) cotter bolts in
the holes. Use a key to turn the nuts on the
cotter bolts, so that they are firmly positioned in
the holes. Unscrew the nuts and put the nuts and
the washers and spring rings aside for later use.
 Place the wall / ceiling brackets on the ceiling or
wall. Put the two (2) cotter bolts through the
holes in the brackets and tighten them with the
washers, spring rings and nuts.
 Position the hanging brackets on the rear side of
the heater. Tighten this firmly with the M6*8
crosshead screws.
 Mount the entire appliance on the wall / ceiling
brackets using the M6*10 socket screws. Use an
Allen key for this purpose.
19