Flex LD 16-8 125 R Notice D'instruction D'origine page 21

LD 16-8 125 R / LDE 16-8 125 R
Adjusting the protective hood
NOTE
The brush ring should protrude approx.
0–1 mm over the sanding plate. The
protective hood can be adjusted in height to
compensate for wear of the diamond
sanding plate.
Release the clamping lever on the

protective hood.
Adjust the protective hood to the desired

height.
Tighten the clamping lever.

Switching the power tool on/off
Short-term operation without detent
Push the rocker switch forwards and

hold.
Release the rocker switch to switch off.

Non-stop operation with detent
Push the rocker switch forwards and

engage by pressing the front part.
NOTE
If there is a power failure, the switched on
power tool will not start running again.
Switching off the equipment:
To switch off, release the rocker switch

by pressing the rear part.
NOTE
The tool will switch off automatically in the
event of a short overload. To restart the tool,
switch off and back on again.
If overheating occurs due to overload during
non-stop operation, the speed of the power
tool will be reduced automatically until the
power tool has cooled down sufficiently. At the
end of the cooling mode, the tool switches off
automatically.
To restart the tool, switch off and back on
again .
21