Flex LD 16-8 125 R Notice D'instruction D'origine page 20

Instructions for use
Before initial operation
Unpack the power tool and accessories and
check that no parts are missing or were
damaged during transport.
Attaching and changing the
abrading tool
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
Press and hold the spindle lock (1.).

Using the stop wrench, loosen the

clamping nut on the spindle in anti-
clockwise direction and remove (2.).
Insert the diamond grinding wheel (A) in

the correct position.
Screw the clamping nut (B) onto the

spindle with the shoulder facing upwards.
Press and hold the spindle lock.

Tighten the clamping nut with the stop

wrench.
20
LD 16-8 125 R / LDE 16-8 125 R
Check the position of the protective

hood.
The brush ring should protrude approx.
0–1 mm over the sanding plate. Adjust if
necessary (see "Adjusting the protective
hood").
Insert the mains plug into the socket.

Switch on the power tool (without detent)

and allow it to run for approx.
30 seconds. Check for imbalance and
vibrations.
Switch off the power tool.

Adjusting the handle
Loosen the handle adjustment knob

approx. 3 turns in anti-clockwise
direction.
Move the handle to the desired position

(15° detent).
Ensure that it engages correctly.
Tighten the handle adjustment knob in

clockwise direction.
NOTE
The handle can be moved to the other side
of the power tool if needed.