Tineco FLOOR ONE S6 Serie Mode D'emploi page 28

Voice Prompt
(Contents may vary,
please in kind prevail.)
Status
Voice prompts on
Voice prompts
disabled
Auto mode by default
Switch to Max mode
Cleaning with water
only
Cleaning with cleaning
solution by default
Battery level: 10~20%
Battery level: 0~10%
Clean Water Tank is
empty
Need self cleaning
Appliance not on the
charging dock
Dirty Water Tank is full
Dirty Water Tank not
installed
Brush roller is tangled
Power is off
Start charging
Begin self-cleaning
cycle.
Battery insufficient for
self-cleaning
Sufficient battery to
start self cleaning
Cleaning brush roller
Cleaning debris
channel
Reminder
Voice prompts on
Voice prompts
disabled
Auto mode
Max mode
Cleaning with water
only
Cleaning with cleaning
solution
Low battery
Low battery, please
charge
Clean Water Tank
empty, please refill
water and cleaning
solution
Please begin self-
cleaning cycle
Please place appliance
on charging dock
Dirty Water Tank full,
please empty
Please install the Dirty
Water Tank
Please clean the brush
roller.
Power off
Charging has
commenced
Auto-detecting
whether to run self-
cleaning cycle, please
begin self-cleaning
cycle
Low battery, start
charging
Start self cleaning
Cleaning brush roller
Cleaning debris
channel
Auto detecting
Deep cleaning
Self-cleaning stopped
Self-cleaning
complete
MAINTENANCE
Note:
• For optimal performance and to prevent odors,
always clean and dry DWT, filters, brush roller,
brush roller cover completely after each use.
• Please make sure each part is installed correctly
or the appliance may not work properly.
• After maintenance, place the appliance on
the charging dock vertically. Do not expose
the appliance to direct sunlight, and store it
indoors in a dry place.
Main Body
1.To reduce the risk of injury, switch off before
performing maintenance.
Fig.D-1
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Fig.D-2
3.When LED loop illuminates red, remove Dirty
Water Tank, clean the dirt sensor with a damp
cloth or the cleaning tool.
Fig.D-3
Dirty Water Tank
1.When dirty water reaches the Max line, the
appliance will stop working, show a reminder
on the display and play a voice prompt.
2.Pull up the tank lid to empty the DWT. Use
the cleaning tool to remove remaining debris.
Rinse the inside of the DWT and place back
into the appliance.
Fig.D-4
26
Auto detecting
Deep cleaning
Self-cleaning cycle
stopped, please clean
Dirty Water Tank
Self-cleaning cycle
complete, please
clean Dirty Water Tank