Seca 286 Mode D'emploi page 94

Activating automatic transmission
Activating/deactivating the wireless
module (system)
94 •
NOTE:
Double-digit channel numbers are displayed without a space. The
display "C230" therefore means: channel "2", channel number "30".
9. Confirm your selection for Channel 2.
The device suggests a channel number for Channel 3 (in this case:
"C360").
You can adopt the proposed channel number or use the arrow keys to set
a different channel number.
10. Confirm your selection for Channel 3.
The message StOP appears in the display.
The device waits for signals from other wireless-capable devices in range.
NOTE:
On some devices, a special switch-on procedure has to be followed if
they are going to be integrated in a wireless group. Follow the Instruc-
tions for Use for the device in question.
11. Switch on the device, e.g. a wireless printer, you want to integrate in the
wireless group.
When the wireless printer is registered, you will hear a beep.
NOTE:
As soon as you have integrated a wireless printer in the wireless
group, you then have to select a print option (Menu\rF\APrt) and set
the time (Menu\rF\tIME).
12. Repeat step 11. for all the devices you want to integrate in this wireless
group.
13. Press the Enter key to stop the search process.
14. Press an arrow key to have displayed the devices which have been
registered (in this case: "Mo 3" for a wireless printer).
If you have integrated several devices in the wireless group, press the
arrow key several times to ensure that all devices have been registered by
the scale.
15. Exit the menu using the Enter key or wait until you exit the menu
automatically.
You can configure the device so that measured results are automatically sent
to all reception-ready receivers and are registered to the same wireless group
(ASEnd)
(e.g.: wireless printer, PC with USB wireless adapter).
NOTE:
If you are using a wireless printer, ensure that "Off" is not set as the
print option (see "Selecting print option (APrt)" on page 95).
1. Switch on the device.
2. Select the "ASEnd" menu item from the "rF" submenu and confirm your
selection.
3. Select the "On" setting and confirm your selection.
You exit the menu automatically.
The device is supplied with an activated wireless module. An activated wire-
less module increases power consumption. You can deactivate the wireless
module if you do not want to use the wireless data transmission option.
1. Switch on the device.
2. Select the "SYS" menu item from the "rF" submenu.
3. Confirm your selection.
The current setting is displayed