Seca 286 Mode D'emploi page 69

Fitting the multifunctional display
2. Push the column element over the threaded rod onto the first column
element.
3. Place the column connector on the second column element in such a way
that the threaded rod protrudes out of the bore in the column connector.
4. Screw the connecting nut onto the threaded rod.
5. Tighten the connecting nut.
The multifunctional display is suspended in the groove of the column
elements and fixed in position with a screw clamp.
ATTENTION!
Malfunction as a result of reflecting multifunctional display
If the multifunctional display is fitted to the first column element, faulty
measurements will result.
►
Fit the multifunctional display to the second column element.
1. Insert the tenon block of the multifunctional display in the groove of the
second column element.
2. Slide the display until it is at the right height for you.
Before you really get started ... • 69
English