Aria PLIXA Mode D'emploi page 39

9.2 IDENTIFYING AND SOLVING BREAKDOWNS
BREAKDOWN POSSIBLE CAUSE
The pressure of one of the rear
wheels is incorrect
One or more spokes are broken
The wheelchair does not
move forward in a straight
line
Spoke tensions are different
The front wheel bearing is dirty
Rear wheels have been
assembled too forward
The wheelchair tips
backwards easily
Excessive inclination of the
Tyre pressure of one or both
rear wheels is incorrect
Brakes intervene incorrectly
or asymmetrically
Brake adjustment is incorrect
Tyre pressure of the rear wheels
Resistance to movement is
very high
Rear wheels aren't parallel
Traction of the front wheel
bearing block is insufficient
Front wheels swerve when
movement speed is high
The front wheel is smooth
Front wheel steers with The ball bearing is dirty or
difficulty or is blocked
34
SOLUTION
Adjust the tyre pressure
> 11.3 Tyres
Replace the broken spoke(s) >
Specialized dealer
Get the tension of the loose
spokes adjusted > Specialized
dealer
Clean or replace the bearing >
or damaged Specialized dealer
Adjust barycentre
> Specialized dealer
Reduce inclination of the
backrest backrest > Specialized dealer
Adjust tyre pressure > 11.3
Tyres
Correct brake adjustment >
Specialized dealer
Adjust tyre pressure > 11.3
is insufficient Tyres
Check that rear wheels are
parallel > Specialized dealer
Slightly block the bolt on
the bearing block axle >
Specialized dealer
Replace the front wheel >
Specialized dealer
Clean or replace the ball
defected bearing > Specialized dealer
10. AFTER USE
10.1 REUSE
The wheelchair can be reused. It is necessary to carry out the following operations:
• Cleaning and disinfection according to descriptions in chapter 8.3 Care and chapter 8.4 Disinfection of this User
Manual.
• Inspection according to description in chapter 8.2 Maintenance plan of this User Manual.
• Adjustment to the user, based on the Technical Assistance documentation available at Aria Wheels Srl main office.
10.2 DISPOSAL
Defend the environment providing an adequate disposal of your wheelchair. Observe the national law and local
regulations for the disposal.
For a correct disposal, contact your specialized dealer or your council's public administration as to get the address of
a local disposal centre.
11. TECHNICAL DATA
11.1 WEIGHT AND DIMENSIONS
All weight and dimension specifications refer to a width of the seat and to its depth in all the possible configurations
of the wheelchair. Dimensions and weight may change according to the different configurations.
Seat width (SW):
Seat depth (SD):
Backrest height (BRH):
Knee-to-heel length (KHL):
Front seat height (SHF):
Rear seat height (SHR):
Centre of gravity (CG):
Backrest angle (BRA):
Rear wheel axle (CRW):
Wheelchair weight SW440 with standard rear
wheels:
Wheelchair weight SW440 without
rear wheels:
Nominal load:
Encumbrance:
The weight depends on the possible configurations. See the product order forms for the specs.
11.2 ENVIRONMENTAL CONDITIONS
Do not expose the wheelchair to temperatures below -20 °C and above 40 °C.
340 - 460 mm ( in increment of 20 mm )
360 - 460 mm ( in increment of 20 mm )
270 - 405 mm ( in increment of 15 mm )
300 - 440 mm ( in increment of 15 mm )
470 - 530 mm ( in increment of 15 mm )
390 - 440 mm ( in increment of 15 mm )
85 - 125 mm ( in increment of 20 mm )
80° - 85° - 90° from the seat
0° or 3°
approximately 10kg
approximately 7.6kg
120kg
approximately 310 - 330mm
35