Rigging The Fixture; Danger Of Fire; Connection To The Mains - Futurelight CC-200 Color changer Mode D'emploi

Install the gobos with the device switched off only.
In order to exchange the gobos open the housing by loosening the fastening screws at the side panels and
by removing the focus-screw and zoom-screw.
If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Unscrew one of the Gobo-screws and loosen the other two. Replace the desired gobo.
Replace the housing cover and tighten the screws.

3.3 Rigging the fixture

When installing the device, make sure there is no highly inflammable
material (decoration articles, etc.) in between a distance of min. 0.5 m.
Make sure that the device is fixed properly! Ensure that
the structure (truss) to which you are attaching the fixtures is secure.
Attach the mounting-bracket to the projector by using the enclosed fixation screws.
Mount the projector with the mounting-bracket to your trussing system. The hole in the mounting bracket has
a diameter of 10 mm.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture.
Adjust the desired inclination-angle via the mounting-bracket and fix the bracket-screws tightly.

3.4 Connection to the mains

Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
DANGER!
Unplug from mains before!

DANGER OF FIRE!

CAUTION!
International
L
N
28