Lamp Adjustment; Overhead Rigging - Futurelight EVO-WATER Mode D'emploi

Lamp adjustment

If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the screws "1, 2, 3" counterclockwise ¼-turn at a time the
light is bright and evenly distributed.

Overhead rigging

The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
The lampholder is aligned at the factory. Due to
differences between lamps, fine adjustment may
improve light performance.
Strike the lamp, open the shutter, set the dimmer
intensity onto 100 % and direct the light towards a flat
surface (wall). Center the hot-spot (the brightest part
of the beam) using the 3 adjustment screws "1, 2, 3".
Turn one screw at a time to drag the hot-spot
diagonally across the projected image. If you cannot
detect a hot-spot, adjust the lamp until the light is
even.
To reduce a hot-spot, pull the lamp in by turning all
three screws "1, 2, 3" clockwise ¼-turn at a time until
the light is evenly distributed.
expert before taking into operation for the
first time and after changes before taking
into operation another time.
The operator has to make sure that safety-
relating and machine-technical installations
are approved by an expert after every four
year in the course of an acceptance test.
The operator has to make sure that safety-
relating and machine-technical installations
are approved by a skilled person once a
year.
Procedure:
The projector should be installed outside
areas where persons may walk by or be
seated.
IMPORTANT!
REQUIRES
including (but not limited to) calculating
25/61
OVERHEAD RIGGING
EXTENSIVE EXPERIENCE,
51837590_V_1_0.DOC