Overhead Rigging - Futurelight EVO-COLOR 250 Mode D'emploi

Overhead rigging

The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
when crashing down! If you have doubts concerning the safety of a possible installation, do NOT install the
projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
IMPORTANT!
REQUIRES
including (but not limited to) calculating working
load limits, installation material being used, and
periodic safety inspection of all installation
material and the projector. If you lack these
qualifications, do not attempt the installation
yourself, but instead use a professional
structural rigger. Improper installation can
result in bodily injury and.or damage to
property.
The projector has to be installed out of the
reach of people.
If the projector shall be lowered from the ceiling
or high joists, professional trussing systems
have to be used. The projector must never be
fixed swinging freely in the room.
Caution: Projectors may cause severe injuries
DANGER OF FIRE!
37/100
OVERHEAD RIGGING
EXTENSIVE EXPERIENCE,
51840870_V_1_0.DOC