Dreame DreameBot X30 Ultra Manuel D'utilisation page 12

Before Use
EN
1. Place the Base Station and Connect to an Electrical Outlet
Place the base station in a location that is as open as possible with a good
Wi-Fi signal. Remove any objects that are closer than 1.5 m from the front and
5 cm from either side of the base station. Insert the power cord into the base
station and plug it into the socket.
Note:
· Make sure that no objects might block the signaling area.
· To prevent water stains from wetting wood floors or carpets, placing the
base station on tile floors or marble floors is recommended.
I : ON
O : OFF
Firmly insert the power cord
upwards until the indicator turns
on.
2. Remove the Protection of Washboard and Install the Ramp
Extension Plate
Remove the protection of washboard, and then put the washboard back
into the base station downwards in an inclined way. Then install the ramp
extension plate down to the base station.
3. Remove Robot Protections and Install the Side Brush and Mop
Assembly
Note: Install the side brush until it clicks into place.
Side Brush
Clip