Assembly
(Fig. B)
Accessory
Assembly
Window
8 ]
[
squeegee
Fiber cover
[
10 ]
Upholstery
[
9 ]
nozzle
Extension
12 ]
[
hose
Extension
[
15 ]
nozzle
Angle nozzle
14 ]
[
Round brush
[
16 ]
Dismount all the accessories in a reverse order.
NOTE: Dismounting the window squeegee
Unlock the clip first.
26 GB/IE
Fit the hooks (at the
back of the window
squeegee
) into the
[
8 ]
slots of the upholstery
nozzle
.
[
9 ]
Press the window
squeegee
against the
[
8 ]
upholstery nozzle
until
[
9 ]
locked.
Fix on the upholstery
nozzle
.
9 ]
[
Attach the intake to
the steam outlet
of
[
1 ]
the product/extension
hose
.
12 ]
[
Screw in a clockwise
direction until tight.
Attach the intake to the
steam outlet
of the
[
1 ]
product, extension hose
or extension nozzle
15 ]
[
Operation
Filling the water tank
m
DANGER! Risk of electric shock! Before
filling the water tank
plug
from the mains socket.
7 ]
[
m
CAUTION! Fill the water tank
or distilled water without any additives.
If your tap water is hard: Use distilled water.
If your tap water is moderately hard: Mix distilled
water and tap water (ratio of 1:1).
NOTES:
As long as there are steam and pressure in
the water tank
valve
. To open the water tank:
[
3 ]
−
Release steam or
−
wait until the product has cooled down.
Do not exceed the water tank's
capacity of 250 ml.
Slowly open the safety valve
opening, wait a few seconds until the steam stops
hissing.
Use the measuring cup
fill the water tank
Close the safety valve
[
12 ]
.
Turning on/off
Connect the power plug
socket.
:
8 ]
[
The power indicator
starts to produce steam immediately.
The product is ready to use when the steam
indicator
18 ]
[
Turning off the product: Disconnect the product
from the mains socket.
: Disconnect the power
[
2 ]
with tap water
[
2 ]
you cannot open the safety
[
2 ]
maximum fill
2 ]
[
. Before fully
3 ]
[
and the funnel
13 ]
[
through the water inlet
2 ]
[
.
3 ]
[
to a suitable mains
[
7 ]
lights up. The product
17 ]
[
lights up.
to
11 ]
[
.
2 ]
[