Publicité
Les langues disponibles
Les langues disponibles
Roll-over sensor
E6
was triggered
Inclination
E7
sensors were
triggered
Docking/re-
E8
charging failed
The robotic
E9
lawnmower is
stuck
Protection of the
E10
battery
No boundary
E11
signal
Charging cur-
E13
rent too high or
too low
EE
Error unknown
Battery thermal
BP
protection
Robotic lawn-
mower locked
LOCK
(PIN entered
incorrectly too
many times)
1. Position the mower.
2. Press the "START" button and then the "OK" button.
1. Switch the mower off.
2. Move the mower to an area in your lawn with level ground.
3. Switch the mower on. Press the "START" button and then the "OK" button.
1. Check that there is 1 metre of space before and after the charging station, without
obstacles or corners.
2. The charging station must be placed on level ground.
3. Manually place the mower in the charging station for charging. After the mower is
fully charged, press the "START" and then the "OK" button.
1. Place the robotic lawnmower in an area that is free of obstacles.
2. If the error still occurs, contact your specialist dealer.
1. If the temperature is too high, wait until the temperature has dropped. If the tempera-
ture is too low, wait until the temperature is above 5 degrees Celsius.
2. If the error message is still displayed, replace the battery. Re-start the mower. Press
START and then OK.
3. If the error still occurs, contact your specialist dealer.
1. When the mower is in the working area, check the charging station LED indicator. If it
lights up red, make sure that the boundary wires are well connected to the terminals
on the charging station. If the problem persists, check whether the boundary wires
have been cut.
1. Check docking area.
2. If the error still occurs, contact your specialist dealer.
1. Re-start the mower.
2. If the error still occurs, contact your specialist dealer.
1. Switch the mower off.
2. Move the mower to an area in your lawn with level ground.
3. Check the temperature of the battery.
4. If the temperature is too high, let the battery cool down.
5. If the temperature is too low, wait until the temperature is higher than 5°C.
6. Re-start the mower.
7. If the error still occurs, replace the battery.
8. If the error still occurs, contact your specialist dealer.
1. Wait 10 minutes and then enter the PIN again.
2. Do not switch the robotic lawnmower off.
3. If the error still occurs, contact your specialist dealer.
GB | 37
Publicité
