Publicité
Les langues disponibles
Les langues disponibles
COMPONENTS
FIG. 7
A
N
A - 120 Volt AC 20 amp receptacles
B - 120/240 Volt AC 30 amp receptacle
C - 120/240 Volt 50 amp receptacle
D - ECO mode switch
E - Reset button
F - 30 amp circuit breaker
G - Parallel operation outlets
MUFFLER AND SPARK ARRESTOR
The spark arrestor prevents sparks from exiting the muffler.
It must be removed for servicing.
NOTICE
The spark arrestor is a safety device
that prevents sparks from exiting the muffler and cre-
ating a fire hazard. In certain locations a spark arrestor
may be required by law. It is the operator's responsi-
bility to know and follow all local laws and regulations
related to fire prevention requirements.
OIL DIPSTICK
Unscrew the oil dipstick to check oil levels and add oil when
needed.
OUTPUT READY LED
Illuminates when the generator is operating normally. In-
dicates the generator is producing electrical power at the
receptacles.
OVERLOAD LED
Indicates that the generator is overloaded.
B
C
F
I
H - Fuel selector switch
I - 50 amp circuit breaker
J - Ground terminal
K - Low oil LED
L - Overload LED
M - Output ready LED
N - AC 20 amp circuit breaker
G
P
O
K
L
M
T
D
E
OVERLOAD RESET
The generator will automatically switch OFF all AC output
to protect the generator if overloaded or if there is a short
circuit in a connected appliance.
PARALLEL OPERATION OUTLETS
A parallel cord (not included) can be used to connect a
compatible Westinghouse inverter generator for additional
power output.
RECOIL HANDLE
Use the recoil handle (and the engine/fuel control switch)
to start the generator.
VENTED FUEL CAP
The fuel cap has a vent that can be opened and closed.
The vent should be open when the engine is running and
closed when the engine is off.
S
H
J
Q
O - Service generator LED
P - Automatic shutoff LED
Q - Propane hose connection
R - Engine switch
S - START/STOP button
T - Smart switch connector (not included)
R
English | 13
Publicité
