Milwaukee 2970-20 Manuel De L'utilisateur page 70

3 M18™ 500GB Control Hub
TM
3.5.3 M18 500GB Control Hub System Update - Over the Air
This section covers updating the M18™ 500GB Control Hub using the Pipeline Inspection
App. This is an over-the-air firmware update and does not require using a USB thumb
drive.
If an M18™ Wireless Monitor is connected to the hub when an over-the-air update is run
both the hub and monitor will be updated if needed.
Firmware updates are periodically released to introduce new features and optimizations.
Before updating a system, go to the About section of the Settings menu and make a note
of the current firmware revisions in the system.
When new firmware is released it is automatically added to the App. When the App
connects to the hub it compares its firmware version to the latest and will ask to be
installed.
1. After the connection to the hub has been established the update message will appear.
Click Install to start the installation process.
2. Confirm the installation after reading the important message by clicking on Install.
3. After the hub has been updated, the update confirmation message will appear and the
hub will reboot. The firmware update has been successful.
THE CONTROL HUB IS UPDATING...
30%
CONTROL HUB UPDATE IS READY FOR
INSTALLATION.
Install
SELECTING OK WILL RUN A FIRMWARE
UPDATE ON THE CONTROL HUB. PLEASE
DO NOT INTERRUPT THE UPDATE
PROCESS AFTER IT HAS STARTED!
OK
66
Cancel
CANCEL
THE CONTROL HUB WAS
SUCCESSFULLY UPDATED AND IT
WILL BE RESTARTED.