Milwaukee 2970-20 Manuel De L'utilisateur page 28

2 M18™ Wireless Monitor
2.2.11 M18™ Battery
Both the M18™ Wireless Monitor and M18™ Control Hub are powered by an M18™
Battery. The battery condition of both is always shown in the status bar on the Wireless
Monitor screen.
Recharge only with the charger specified for the battery. For specific
charging instructions, read the operator's manual supplied with your charger and
battery.
33kHz
02/22/2024 10:04:50 PM
M18™ 500GB Control Hub – The Control Hub is powered by its M18™ Battery which is
hot-swappable. If the battery is removed from a running Control Hub, the below message
will appear warning that the Control Hub is operating on the internal backup battery for
a period of nine minutes. During these nine minutes a charged M18™ Battery must be
installed, or a USB-C cable must be attached between the Wireless Monitor and Control
Hub. The USB-C cable will now power the Wireless Monitor temporally.
Typical battery life: M18™ Wireless Monitor: Nine hours on a fully charged battery
M18™ 500GB Control Hub: Nine hours on a fully charged battery
33kHz
02/22/2024 10:04:50 PM
2024_02_22_A
512Hz CAMERA LIGHT
Battery status – the icon to the left represents the battery status
of the Control Hub while the icon to the right represents the battery
status of Wireless Monitor.
512Hz CAMERA LIGHT
REPLACE CONTROL HUB BATTERY
OR CONNECT CABLE TO WIRELESS
MONITOR IMMEDIATELY
TIME REMAINING : 08:51
24
15° 9'3''
15° 9'3''