Milwaukee 2970-20 Manuel De L'utilisateur page 25

2 M18™ Wireless Monitor
2.2.10 Connection Settings
The default connection method for M18™ Wireless Monitor and M18™ 500GB Control
Hub is via Wi-Fi. The wireless range between the two units is 200'. If an active Control
Hub is within the 200' range, it will show here in the Control Hub List. As a backup, the
Wireless Monitor and Control Hub can be connected by using the provided USB-C cable.
First-time Wireless Monitor Paring
• If only one Control Hub is in range, the Wireless Monitor will automatically force pair
with it without any user interaction.
• If there is more than one Control Hub in range, the Control Hub List will appear on the
Wireless Monitor or Milwaukee
desired Control Hub.
• If prompted for a password enter: 29702000
33kHz
SEARCHING FOR NEARBY CONTROL HUBS
a
MECAM_15100002F
a. List of nearby Control Hubs with active Wi-Fi
b. Status – checkmark indicates as connected
c. Signal strength of nearby Control Hubs with active Wi-Fi
Battery Capacity – Both M18™ Battery icons have four segments in the icon. Each
segment represents 25% of the battery's power capacity. A low battery warning will
appear when the capacity reaches 10%
®
Pipeline Inspection App so the user can choose the
512Hz SETTINGS
Control Hub List
Cable Connected icon – Shows the Wireless Monitor and Control
Hub are connected by a USB-C cable.
Control Hub connection status and wireless signal strength. This
icon appears when the Control Hub is connected to the Wireless
Monitor by Wi-Fi.
Pipeline Inspection Reel icon – appears when the Wireless Monitor
and Control Hub are connected by Wi-Fi or USB-C cable.
M18™ Battery Status icons – The larger icon on the right
represents the Wireless Monitor while the smaller icon on the left
represents the Control Hub.
21
b
c