Milwaukee 2970-20 Manuel De L'utilisateur page 32

2 M18™ Wireless Monitor
2.3.1 Using Jobs
Before creating a video or image file, you can tell the system where to store the files.
This is known as creating a New Job or Continue Existing Job. Creating a New Job will
setup a container (folder) for both video and image files to be stored in. Continue Existing
Job will route the recordings to a Job folder that already exists.
The system will automatically ask which Job to use in certain situations.
Whenever the system clock changes to a new day. (after 11:59 PM)
Whenever the M18™ Wireless Monitor is restarted. (turned off and on again)
Whenever the M18™ 500GB Control Hub is restarted. (turned off and on again)
When the Record button is pressed under the above situations, the Select Job List will
appear with options of: New Job With Date And Time or New Job With Name or Existing
Job. From this point on the same Job will be used until changed.
When the storage space becomes low a pop-up message will appear prompting to delete
some jobs to free up space.
1. Turn the navigation dial to Settings
2. Turn the navigation dial to Manage Jobs, press the navigation dial to enter the sub-menu.
The Manage Jobs sub-menu has five menu options.
33kHz
NEW JOB WITH DATE AND TIME
NEW JOB WITH DATE AND NAME
CONTINUE EXISTING JOB
EXPORT JOB
DELETE JOB
a. New Job With Date And Time – Creates a New Job with the system's date and
time as the prefix for all files in this folder.
b. New Job With Date And Name – Creates a New Job with the system's date and
time followed by the entered Name for all files in this folder.
c. Continue Existing Job – Will send the new files to an Existing Job previously
created.
d. Export Job – Copies the Job from the Control Hub Internal Drive to a Control Hub
Thumb Drive.
e. Delete Job – Deletes the Job from the Control Hub Internal Drive.
, press the navigation dial.
512Hz SETTINGS
28