14. Installez la rampe du panier à l'aide de charnières. Installez des
ressorts de rampe de panier sur les supports fournis. Pour la
circulation de l'air et l'assainissement approprier, la rampe de
panier doivent toujours être installées..
15. To install the shovel:
a. Insert the round end of the cross shaft into the hole on the
right side of the door wall (as viewed from the inside of the
door)
b. Maneuver the left slide with the rectangular drive into the
open slot on the left. Rotate the back door of the shovel so
it points down, this will ensure the linkage actuates properly.
c. Align the rails on the shovel body with the openings on the
drawer body and slide the shovel forward.
16. As the shovel moves forward the back door should rotate
upwards, ensure the long tabs are inside the shovel as closes.
Push the shovel all the way forward into the drawer.
17. Rotate 180° clockwise to secure in place.
18. The USB port for this unit is located next to the circuit breaker on
the back of the unit. This is used to log diagnostic information,
import or export recipe and control information. Keep the screw
top in place when not in use to ensure the port stays clean.
19. There is a circuit breaker located in the upper right corner on the
back of the unit, this must be turned on for the unit to operate.
SÉRIE PFA INSTALLATION, INSPECTION, ENTRETIEN
1
3
2
18