Vapormed Volcano Medic 2 Mode D'emploi page 92

5. T H E V O L C A N O M E D I C 2 H O T A I R G E N E R AT O R
5.7. Keys Combination
The table below gives an overview of commands that can be entered on the
display using key combinations:
Key command
Press the touch button
'HEAT'
Press the touch button
'AIR'
Tap the touch button
Temperature Plus
Tap the touch button
Temperature Minus
Keep the touch button
Temperature Plus
pressed
Keep the touch button
Temperature Minus
pressed
Simultaneous activation
of the touch button
Temperature Plus and
Minus
Press the touch button
'Heat' for 10 seconds
while VOLCANO
MEDIC 2 is switched on
Result
Switching on the heating
Switches on the pump
Increases the set value in 1-degree increments
Reduces the set value in 1-degree increments
Continuous increase of the set value
Continuous decrease of the set value
Changing the display from degrees Celsius to de-
grees Fahrenheit and vice versa
Carry out the factory reset, which is confirmed by a
run sequence on the LCD. This affects the following
feature:
- Resets the set temperature to 180°C (356°F)
Note: the unit previously displayed (°C or °F) is main-
tained following the factory reset
93