Publicité
Les langues disponibles
Les langues disponibles
10.1. Cleaning
Before maintenance, the device has to
be switched off and the power plug has
to be unplugged.
For home use it is sufficient to clean
the housing of the Hot Air Generator
with a damp cloth. Do not hold the de-
vice under running water.
Alternatively, in domestic applications,
the Housing of the Hot Air Generator
can be cleaned and disinfected with a
surface disinfectant (details are given
in the following cleaning and disinfec-
tion instructions for use in doctor's
surgeries and hospitals).
In a physician's office or clinic, the
housing of the Hot Air Generator can
be cleaned and disinfected with a sur-
face disinfectant.
The surface disinfectant should be
certified (e.g. VAH/DGHM or FDA ap-
proval or CE marking), be suitable for
disinfecting the Hot Air Generator, and
compatible with the Hot Air Generator
(see Chapter 9.2. "Material Resistance
of the VOLCANO MEDIC 2 Vaporizati-
on System", page 116).
Use only a soft clean cloth for wiping.
The cloth may be damp, but not wet.
Prevent liquid from entering the Hot Air
Generator.
10. H O T A I R G E N E R AT O R
123
If a cleaning spray is being
used, it should be applied
onto a cloth with which the
device is then wiped. Do not spray
cleanser directly onto the device.
Liquid entering the Hot Air Generator
can damage the electrical parts and
cause malfunctions.
If any liquid does get into the Hot Air
Generator, contact our Service Center
immediately.
10.2. Care and Maintenance
Prior to undertaking any maintenance
work, the device must be switched
off and disconnected from the power
supply.
At the bottom of the Hot Air Genera-
tor is an Air Filter. The Air Filter must
be inspected for contamination every
four weeks, and changed as necessa-
ry. To do this, open the rectangular flap
on the bottom of the Hot Air Generator
and exchange the Air Filter.
Please pay attention to the cor-
rect positioning of the Air Filter:
it has three large and one small
rounded corner.
Publicité
