Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-198-005.book Page 40 Tuesday, August 31, 2010 10:36 AM
40 | English
Preparing for Operation
Clamping the Workpiece (see figure F)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
– Press the workpiece firmly against the
fence 18.
– Insert the material clamp 42 provided into
one of the holes 16 intended for it.
– Loosen the wing bolt 43 and adapt the mate-
rial clamp to the workpiece. Tighten the wing
bolt again.
– Firmly clamp the workpiece by turning the
threaded rod 44 in clockwise direction.
Adjusting the Cutting Angle
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use (see "Checking
and Adjusting the Basic Adjustment", page 45).
Always tighten the locking knob 11 firmly
before sawing. Otherwise the saw blade can
become wedged in the workpiece.
Adjusting Mitre Angles (see figure G)
The mitre angle can be set in the range from 50°
(left side) to 58° (right side).
– Loosen the locking knob 11 in case it is tight-
ened.
– Pull the lever 12 and turn the saw table 8 un-
til the desired mitre angle is indicated on the
angle indicator 13.
– Tighten the locking knob 11 again.
For quick and precise setting of often used mi-
tre angles, detents 14 are provided on the saw
table:
Left
Right
0°
15°; 22.5°;
15°; 22.5°;
30°; 45°
30°; 45°
– Loosen the locking knob 11 in case it is tight-
ened.
1 609 929 X05 | (31.8.10)
– Pull lever 12 and rotate the saw table 8 left
or right to the requested detent.
– Release the lever again. The lever must be
felt to engage in the detent.
Adjusting Bevel Angles (see figure H)
The bevel angle can be set in the range from 0°
to 45°.
– Loosen the clamping lever 21.
– Tilt the tool arm by the handle 5 until the an-
gle indicator 20 indicates the desired bevel
angle.
– Hold the tool arm in this position and retight-
en the clamping lever 21.
For quick and precise setting of the standard
angles 0° und 45°, end stops are provided on
the housing.
– For this, tilt the tool arm by the handle 5 to
the stop toward the right (0°) or to the stop
toward the left (45°).
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On (see figure I)
– For starting operation, pull the On/Off
switch 4 in the direction of the handle 5.
Note: For safety reasons, the On/Off switch 4
cannot be locked; it must remain pressed during
the entire operation.
The tool arm can be guided down only after
pushing the locking lever 35.
– For sawing, the locking lever 35 must be
pushed in addition to pressing the On/Off
switch.
Switching Off
– To switch off the machine, release the
On/Off switch 4.
Bosch Power Tools
Publicité
