Thermador Professional PRO-GRAND PD30 Instructions D'installation page 14

Step 4: Installing Anti-Tip Device
30 and 36 Inch Ranges (Figures 7A and 7B)
Thermador Service Part No. Qty Description
415078 4 Screw, Phillips, #10 x 1-1/2"
487310 1 Anti=Tip Bracket, Floor=Mounted
_MPORTANT _NSTALLAT_ON _NFORMAT_ON:
• The anti-tip bracket may be attached to a solid
wood cabinet having a minimum wall thickness of
314'L
The thickness of the wall or floor may require use
of longer screws, available at your local hardware
store.
In all cases, at least two (2) of the bracket mount-
ing screws must be fastened to solid wood or
metal.
• Use appropriate anchors when fastening the
mounting bracket to any material other than hard-
wood or metal.
• Prepare holes at fastener locations as identified
below:
For walls, wall studs, or floors composed
of solid wood or metal, drill 1/8" pilot holes.
F_G. 7A - Mounting Anti-tip Bracket
o
o[
t o
/
J
For walls or floors composed of drywall,
sheet-rock or other soft materials, drill 3/16"
holes to a minimum depth of 1-3/4", then tap
plastic anchors into each of the holes using
a hammer.
For walls or floors composed of concrete or
concrete block, drill 3/16" holes to a mini-
mum depth of 1-3,'4", then tap concrete
anchors into each of the holes using a
hammer.
For walls orfloors having ceramic tile cover-
_, dnll 3/16" holes through the tile only, then
drill into the material behind the tile as indi-
cated immediately above.
If the range is moved to a new location, the Anti-
Tip Device must be removed and reinstalled.
MOUNTING ANTI-TIP BRACKET
The alternative floor mounted bracket shall be installed
as follows:
a) Place bracket on floor in position shown in Figure
7B.
b) Secure to floor or wall stud.
c) Later, when the unit is installed, the adjustable leg
will slide under the bracket.
FIG. 7B
- Placement of Anti-tip Bracket (Top View)
Wall Line
Cabinet
Floor
./ /
\--
If< 2-i,,'z'
Front Edge of I
(typ ca
=
Right Cabinet I
either side)
:_1 2ol/2" _ from edge of range
\
11