Maintenance - Health O Meter PROPLUS 2000KL Mode D'emploi

SET UP (CONTINUED)
1. Unplug the scale.
2. Remove the battery cover from the display assembly (A)--see Figure 6 on page 12.
3. Disconnect battery holder cable connector from the scale-battery connector (B).
4. Carefully remove the battery holder by sliding it out of the display assembly (C).
5. Replace the batteries with new ones. We recommend EVEREADY Energizer
6. Carefully slide the battery holder into the display assembly.
7. Plug the battery holder cable connector to the scale-battery connector.
8. Attach the battery cover to the display assembly and install the screw.
Warning: If the scale will not be used for some time, remove batteries to avoid a safety hazard.

MAINTENANCE

GENERAL
This section provides instructions for maintenance, cleaning, troubleshooting and operator
replaceable parts for the ProPlus
those described in this section should be performed by qualified service personnel.
MAINTENANCE
Before first use and after periods of non-use, check the scale for proper operation and function. If the
scale does not operate correctly, refer to qualified service personnel.
1. Check overall appearance of the total scale for any obvious damage, wear and tear.
2. Inspect AC adapter for cord cracking or fraying or for broken or bent prongs.
CLEANING
Proper care and cleaning is essential to ensure a long life of accurate and effective operation.
Disconnect the scale from the AC power source.
1. Clean all external surfaces with a clean damp cloth or tissue. Mild antimicrobial or antibacterial
soap and water solution may be used. Dry with a clean soft cloth.
2. Do not immerse the scale into cleaning or other liquid solution.
3. Do not use Isopropyl Alcohol or other solutions to clean the display surface.
4. Do not use abrasive cleaners.
®
Stretcher Scale Model 2000KL. Maintenance operations other than
- 13 -
®
e2 batteries.
TM