Health O Meter PROPLUS 2000KL Mode D'emploi page 13

SET UP
The Model 2000KL ProPlus® Stretcher Scale is shipped with the Menu Lock function enabled.
The Menu Lock function disables certain buttons on the scale's keypad, thus preventing
unauthorized users from making changes to your scale settings. The Menu Lock can be bypassed
temporarily to allow you to customize your scale with the functionality you prefer. Please refer to
page 7 of the ProPlus® Display Module User Manual for instructions on how to bypass the Menu
Lock.
Preparing the Scale for Use
1. Remove protective plastic film from keypad and display.
2. Place batteries in the battery holder (see "Replacing Batteries" information in Figure 6, below).
3. Plug the scale's AC adapter into the power source.
4. Press the ON/OFF button to turn the scale on. The display will show "Health o meter ProPlus"
and then "000 00
Lb
page 13 of the ProPlus® Display Module User Manual.
5. Hang the stretcher on the Stretcher Hoops. The display will show "WEIGHING" and/or
"REWEIGHING" until a stable weight is calculated. The weight of the stretcher will be
displayed. (See page 4 on more information regarding pre-weighing the stretcher and the
TARE function).
6. Press the TARE key and the scale will zero out.
7. Place a weight that is WITHIN the scale's capacity on the stretcher (see page 3 for more
information). The display should read "WEIGHING" until the weight calculation is complete and
the weight is displayed.
8. Press the KG/LB button to select the weight mode (pounds or kilos). To change the display
mode in pounds to fractions or decimals, please refer to page 7 of the ProPlus® Display Module
Manual.
9. Press the REWEIGH button; and the scale will perform the weighing process again (you do not
have to remove the applied weight to repeat the weighing process).
10. Remove the weight from the stretcher. The scale will return to zero and the display will read
"TARE" on the upper right side of the screen along with
11. When you disconnect the scale's AC adapter from the power source, the scale will switch to
battery power.
Note: If the set up procedure failed, refer to the troubleshooting instructions. If the problem
is not corrected, refer to qualified service personnel.
Note: The scale will always default to the settings and units last used.
Replacing / Inserting Batteries
". Note: To adjust the display backlight and/or contrast, please refer to
oz
Figure 6 - Batteries
"000 00
Lb oz
- 12 -
".