5.1Ch/Sat Hookups - Sony HT-K215 Mode D'emploi

5.1CH/SAT Hookups

Although this amplifier incorporates a multi channel
decoder, it is also equipped with 5.1CH/SAT jacks. These
connections allow you to enjoy multichannel software
encoded in formats other than Dolby Digital (AC-3) and
DTS. If your DVD player is equipped with 5.1CH
OUTPUT jacks, you can connect them directly to the
amplifier to enjoy the sound of the DVD player's multi
channel decoder. Alternatively, the 5.1CH/SAT jacks can
be used to connect an external multi channel decoder.
To fully enjoy multi channel surround sound, you will
need five speakers (two front speakers, two rear speakers,
and a center speaker) and a subwoofer. Refer to the
instruction manual supplied with your DVD player, multi
channel decoder, etc., for details on the 5.1 channel input
hookups.
Multichannel decoder, etc.
5.1CH OUTPUT
CENTER
WOOFER
DVD
AUX
TV
Example of a DVD player hookup using the 5.1 CH/SAT jacks
DVD player
Note
See page 11 for details on speaker system hookup.
8 GB
DVD player,
REAR FRONT
L L CENTER
R R
WOOFER
VIDEO FRONT REAR
5.1 CH/SAT
VIDEO
?/1
SURR LEVEL SET UP
– +
Required cords
Audio cords (not supplied)
Two for the 5.1CH/SAT FRONT and REAR jacks
White (L)
Red (R)
Monaural audio cords (not supplied)
Two for the 5.1CH/SAT CENTER and WOOFER jacks
Black
Note
When using the connections described below, adjust the level of
your surround speakers, center speaker and subwoofer from the
DVD player or multichannel decoder.
L
R
OUT FRONT REAR
SPEAKERS
FRONT
MASTER VOLUME
R
TV DVD AUX 5.1CH/SAT
SPEAKERS
REAR/CENTER
SUB WOOFER
– +
SOUND FIELD MODE
White (L)
Red (R)
Black
Front Speaker (L)
Front Speaker (R)
Rear Speaker (L)
Rear Speaker (R)
Center Speaker
Active Woofer