Hooking Up The Components; Unpacking; Inserting Batteries Into The Remote; Before You Get Started - Sony HT-K215 Mode D'emploi

Hooking Up
the
Components
This chapter describes how to connect
various audio and video components
to the amplifier. Be sure to read the
sections for the components you have
before you actually connect them to
the amplifier.
4 GB

Unpacking

Check that you received the following items with the
amplifier:
• Remote commander (remote) (1)
• Size AA (R6) batteries (2)
• Speakers
• Front speakers (2)
• Rear speakers (2)
• Center speaker (1)
• Subwoofer (1)
• Speaker connecting cord, long (2)
• Speaker connecting cord, short (3)
• Monaural connecting cord (1 phono to 1 phono) (1)
• Foot pads (20)
• Screw (1)
• Amplifier stand (1)

Inserting batteries into the remote

Insert R6 (size-AA) batteries with the + and – properly
oriented in the battery compartment. When using the
remote, point it at the remote sensor g on the amplifier.
z
When to replace batteries
Under normal conditions, the batteries should last for about 6
months. When the remote no longer operates the amplifier,
replace all batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor to direct sunlight or lighting
apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.

Before you get started

• Turn off the power to all components before making
any connections.
• Do not connect the AC power cords until all of the
connections are completed.
• Be sure to make connections firmly to avoid hum and
noise.
• When connecting an audio cord, be sure to match the
color-coded pins to the appropriate jacks on the
components: white (left, audio) to white; and red (right,
audio) to red.
]
}
}
]