EUROM 363463 Manuel D'utilisation page 38

ATTENTION! If you want the stove to operate according to a timer programme, it will not
only have to remain on stand-by, but also switched on (using the ON/OFF button). If this is
not necessary, always switch off the stove using the ON/OFF button, switch off the main
switch and remove the plug from the socket.
Switching off
If you are not using the stove, you must switch it off using the main switch (you press O)
and remove the plug from the socket. Doing this will erases all the settings, also day and
time. Only the timer settings are stored.
Protection
The Malmo atmospheric fireplace is equipped with an overheating protection. The
overheating protection switches the heater off if it overheats internally. This may occur if
the heater cannot give off enough heat or if it cannot draw in enough fresh air. As
mentioned above, this is generally caused by (partially) covering the heater, obstructing
the air intake and/or outlet grills or installing the heater too close to a wall or something
similar.
If this happens, turn the fireplace off by switching the main switch to O and remove the
plug from the socket. Leave the fireplace to cool down for at least 15 minutes and remove
the cause of overheating. You can then switch the fireplace back on.
If the device overheats again or you cannot ascertain the reason for this, take the fireplace
to your service point to be checked/repaired.
Important! For safety reasons the fire will not automatically restart after overheating.
Check whether conditions are safe before switching it on! So never switch on the heater
by means of a timer and never connect it to a power supply that regularly switches on and
off.
Cleaning and maintenance
Always remove the plug from the socket and let the fireplace cool down before cleaning or
touching. The Malmo atmospheric fireplace does not need much maintenance. Always
keep the in- and outlet openings clean and dust-free. Use a soft cloth or a soft brush to
clean the outside of the metal case. The glass plate can also be cleaned with a soft cloth.
Do not use abrasive cleaning fluids or special glass cleaners! If the device malfunctions,
immediately remove the plug from the socket and take to a service point. Do not carry out
repairs yourself and always ask for original parts to be used. If the fireplace is to be stored
after the winter period, clean it, pack it in original packaging if possible and store in a cool,
dry and clean place. Make sure the fireplace is kept upright.
38