EUROM 363463 Manuel D'utilisation page 35

Operating
 Check that the details on the data plate correspond to those of the electrical supply
which you wish to use for the fireplace. Do not use the same connection for any other
group
 Install two AAA-1,5V batteries in the remote control.
 Check whether the main switch is set to OFF (O is pushed in)
 Now insert the plug into the grounded socket.
 Push the main switch to ON (I is pushed in). The fireplace is now on stand-by and the
light is switched on at the display .
 You can now further operate the fireplace with the remote control or with the buttons
on the fireplace itself.
Push-button operation:
If you don't use the remote control, you can press the relevant buttons on the control
panel, manually set it to 3 positions; the corresponding lights will turn on.
- I/O : flame effect only
- I/O + 1000W : flame display and heating at 1000W
- I/O + 2000W : flame display and heating at 2000 Watt
By pressing the I/O button longer, you initiate the dimmer function; the light intensity will
increase or decrease with every tweet. Release the button when you have achieved the
desired intensity
Attention! The thermostat cannot be set manually, only with the remote control. The
thermostat is standard set to 20°C.
Remote control:
 Press on the ON/OFF button to switch on the stove.
 Now set the desired temperature. The temperature & timer setting will usually show
the ambient temperature. By pressing on the + or - button, you see the set
temperature flashing for a short time and by pressing the + or - buttons, you can
adjust the temperature (from 15 to 30°C). After a few seconds, the display switches
back to the ambient temperature and the newly desired temperature is set. The
temperature is standard set to 20°C.
 Now you can start operating the stove by pressing the button to 1000W (half output)
or 2000W (full output). When the set temperature is above the ambient temperature,
the stove will start to heat (1000W, 2000W). The corresponding lights on the display
are turned on (1000W-1 star, 2000W-2 stars).
If you press the
the display are turned on (
 The thermostat will switch off the stove as soon as the stove reaches the desired
temperature and it will switch it on again if the ambient temperature drops.
 By pressing the 'dimmer' button (there are 5 positions), you can intensity or decrease
the flame effect of the stove.
button, the window detector will start. The corresponding lights on
).
35