Fault Finding - SDMO SD 6000 TE-2 Manuel D'utilisation Et D'entretien

9. Fault finding

The generating set is under load during start-up
Fuel level too low
Manual control (no.2 diag.C) on stop
The engine does not Fuel supply blocked or leaking
start
Blocked air filter
Faulty battery (electrical starting fault)
"Emergency stop" push button engaged
Diesel pump/control unit feed fuse fault
Blocked ventilation inlets
Possible overload
Diesel pump/control unit feed fuse fault
The engine cuts out
Working hours counter/fan feed fuse fault
Low oil
Insufficient genset ventilation
Circuit breaker tripped out
Faulty circuit breaker
No electrical current
Faulty socket
Faulty appliance leads
Faulty alternator
Circuit breaker trips
out
Faulty equipment or lead
10. Specifications
Model
Engine type
Output (Watts)
Direct current
Current
Socket type
Circuit breaker
Oil cut-out
Genset high temperature cut-out
Battery
Acoustic pressure at 1 m
Weight in kg (without fuel)
Dimensions l x w x h in cm
Recommended oil
Oil sump capacity in L
Recommended fuel
Fuel tank capacity in L
Heater plug
Control unit and diesel pump feed fuse
Working hours counter and fan feed fuse
●: standard
Probable causes
Probable causes
Probable causes
Probable causes
○: optional X: not possible
Remove the load
Fill up with fuel
Return to "ON"
Have the system repaired
Clean the air filter
Recharge or replace the battery
Disengage the "emergency stop" push button
Replace the fuse and look for the cause of the
blowout
Clean the air inlet and outlet guards
Check the load
Replace the fuse and look for the cause of the
blowout
Replace the fuse and look for the cause of the
blowout
Check the level
Move the genset to a more suitable area
Reset the circuit breaker
Have it checked, repaired or replaced
Have it checked, repaired or replaced
Change the leads
Have it checked, repaired or replaced
Have it checked, repaired or replaced
SD 6000 TE-2
YANMAR L100 E
1x 230V-16A-2P+T 1x 230V-10/16A-
91 x 79 x 113
Remedial action
Remedial action
Remedial action
Remedial action
5200
X
230V/22.6A
1x 230V 32A-2P+T
2P+T
●
●
●
12V-26Ah
82 dB (A)
193
SAE 15W40
1,65
Diesel
26
X
5A/12VDC
2A/230VAC