GYS PROTIG 201 DC FV Manuel D'utilisation page 26

Operating manual
MMA STANDARD
This standard MMA welding mode is suitable for most applications. It allows welding with all types of coated electrodes, rutile, basic and on all mate-
rials: steel, stainless steel and cast iron.
Designation
Percentage of Hot Start
Welding current
Arc Force
Pulse MMA
This MMA Pulse welding mode is suitable for applications in the vertical up position (PF). The pulse mode keeps the weld pool cold and eases the
transfer of matter. Without the pulse mode, vertical-up welding requires a difficult «Christmas tree» shape triangular movement. With the MMA Pulsed
mode, this movement is no longer required and a simple straight up movement is enough (depending on the thickness of the workpiece). If you wish
to widen your weld pool, a simple lateral movement is enough (similar to standard welding). This process allows greater control during vertical-up
welding.
The pulse frequency is adjusted by pressing and releasing the «F(Hz)» button and then activating the main incremental encoder. Frequency value
increases when the incremental encoder is operated clockwise and decreases when it is operated anti-clockwise. Once the setting is set, it is possible
to press and release again the «F(Hz)» button to re-link the main incremental encoder to the current setting or to wait 2 seconds.
Designation
Percentage of Hot Start
Welding current
26
Translation of the original
instructions
The grey areas are not useful for this mode.
Setting Description & advice
The Hot Start is an overcurrent during priming to prevent the wire from sticking to the part to be
0 - 100 %
welded. It is set in Intensity and Time.
The welding current is adjusted according to the type of electrode chosen (refer to the electrode
10 - 200 A
packaging).
The Arc Force is an overcurrent delivered when the electrode or drop comes into contact with the
-10 / +10
solder bath in order to avoid sticking.
The grey areas are not useful for this mode.
Setting Description & advice
The Hot Start is an overcurrent during priming to prevent the wire from sticking to the part to be
0 - 100 %
welded. It is set in Intensity and Time.
The welding current is adjusted according to the type of electrode chosen (refer to the electrode
10 - 200 A
packaging).
MMA Standard
MMA PULSE
PROTIG 201 DC FV