Harvia Sentiotec Pro D2W Mode D'emploi page 19

Installation instructions, for professionals only
To install the sauna control unit, perform the following steps:
1. Screw two cross-head screws (16 mm) into the wall of the sauna at a height
of approx. 1.70 m and leaving a protruding length of 7 mm. The two screws
must be placed at a distance of 145 mm from each other (see Fig. 2).
80
40
Fig. 2 Position of the attachment device and the installation holes
(dimensions in mm)
2. Press the clip locks C in lightly using a screwdriver and remove the cover
from the housing (see Fig. 3).
3. Fasten the sauna control unit onto the cross-head screws using the attach-
ment device A as an aid (see Fig. 2).
4. Screw two cross-head screws (16 mm) into the lower fastening holes B
(see Fig. 2).
Fig. 3 Removing the cover from the housing
145
C
p. 19/70
82
A
B
43
EN