SilverCrest SV 125 C5 Mode D'emploi page 20

Vacuum sealing containers
1) Connect the vacuum hose u onto the suction fitting
2) Select the appropriate adapter i/o/p for the container you want to
vacuum and attach it to the vacuum hose u.
3) Close the appliance lid 1. Ensure that both corners of the appliance lid 1
click closed. If necessary, press them down once again on the markings
and
4) Connect the adapter i/o/p to the appropriate fitting on the container.
Please refer to the instruction manual of the container for further information.
5) Press the
sucks the air out of the container. As soon as all the air is sucked out, the
control lamp z goes out.
6) You can now remove the adapters i/o/p from the container and the
appliance.
Cleaning
DANGER
Risk of fatal injury from electrocution!
► Remove the plug from the mains power socket before beginning to clean
the device.
► Ensure that no moisture can penetrate the device during cleaning.
CAUTION
Possible damage to the appliance.
► Do not use aggressive or abrasive cleaning agents, as these may corrode
the surface of the casing.
► Do not use any hard or sharp objects to remove any adhesive from the
welding wire 4. Otherwise the welding wire 4 or the insulation could
be damaged.
Cleaning the appliance
♦ Clean the surface of the housing of the appliance with a lightly moistened
cloth and a mild detergent.
Wipe off the upper 0 and the lower sealing rings 5, as well as the press
♦
seal q with a damp cloth. Ensure that the appliance is dry before using it again.
Wipe the vacuum hoses u, and the adapters i/o/p with a damp cloth. If
♦
there is heavy soiling, you can also clean these parts in hot water with a little
detergent. Ensure that all components are completely dry before the next
use.
SV 125 C5
so that the appliance lid 1 clicks into place and locks shut.
button z. The control lamp z lights up and the appliance
9 of the appliance.
GB │ IE │ 17 ■