AUTOFRY MTI-5 Mode D'emploi page 7

AutoFry
MTI-5 Operator's Manual
Set-up & Installation:
The AutoFry comes from the factory complete with everything you need to start cooking except food and
oil. Following these simple instructions will have your AutoFry installed and ready to earn profits for you
in as little as 30 minutes.
Motion Technology, Inc. is not responsible for local requirements that additional equipment and / or
appliances may be required for a food preparation area in a store, which may include but not limited to
Type II hood, vent fan, grease interceptors and additional sinks. Check with your local building and / or
health departments for specific requirements.
Prepare Electrical Service:
A licensed electrician in accordance with the National Electrical Code (NEC) and all local codes must install
the electrical service. Do not remove or otherwise alter the factory supplied power cord or plug. Never
attach the AutoFry to an extension cord. Consult the identification tag for equipment wattage and voltage.
Motion Technology, Inc. will not assume responsibility for any injuries or equipment
malfunctions resulting from non-conforming electrical installations.
Prepare Counter Top:
Choose a countertop location that is sturdy, level, easily cleanable and fire resistant. Stainless steel, fire
resistant laminate or solid surface materials are acceptable. Never use a porous material to prepare food
as bacterial contamination could result.
63-0132 MTI-5 TS OM 01/24 5