AUTOFRY MTI-5 Mode D'emploi page 12

13.
Add commercial grade frying oil.
•
With the drain valve closed, add oil to the oil pot. Fill to the lower fill line stamped COLD on
the interior of the oil pot.
It is easier and safer to add cool oil to the oil pot than it is to remove hot oil. When heated,
the oil will expand.
Over filling will result in excessive splashing. Under filling will result in under cooked food
or poor and erratic temperature readings. Extreme low oil levels could cause smoking.
Older / degraded oil has a reduced flash / smoke point.
Follow the oil manufacturers recommendations for oil use.
NEVER operate the AutoFry with low or no oil!
14.
Install the Teflon Cook Basket.
•
Insert the flat end of the basket rod into the slot in the basket
cam located on the back wall of the cook chamber. Figure 10A.
•
Install the round end of the basket rod into the receiver clip on
the inside front of the cook chamber. Figure 10B.
IMPORTANT
The completed installation will have the basket positioned at an angle
above the oil pot. Figure 11. This is normal.
Do not force the basket down into the oil pot or damage to the
basket motor will result.
When adding oil, remove the Teflon cook basket. Never use the basket
as a rest for the oil container.
15.
Power.
•
Close and lock the main door.
•
Plug the AutoFry into the
properly rated, grounded outlet.
You are now ready to start cooking!
63-0132 MTI-5 TS OM 01/24
AutoFry
MTI-5 Operator's Manual
10
Square end of basket
rod installs in cam
Figure 10A
Round end of basket rod
slips into receiver clip
Basket
Figure 10B
Figure 11