Important Safety Instructions - SMA SUNNY HIGHPOWER PEAK1 Instructions D'installation

2 Safety
compliance or non-compliance with such laws or
codes in connection with the installation of the
product.
The type label must remain permanently attached to
the product.
2.2 IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
The product has been designed and tested in
accordance with international safety requirements.
As with all electrical or electronical devices, there are
residual risks despite careful construction. To prevent
personal injury and property damage and to ensure
long-term operation of the product, read this section
carefully and observe all safety information at all
times.
Danger to life due to electric shock when live
components or cables of the inverter are
touched
High voltages are present in the conductive
components or cables of the inverter. Touching live
parts and cables of the inverter results in death or
lethal injuries due to electric shock.
• Disconnect the inverter from voltage sources and
make sure it cannot be reconnected before
working on the device.
• After disconnection, wait 60 minutes until the
capacitors have discharged.
• Wear suitable personal protective equipment for
all work on the product.
• Do not touch non-insulated parts or cables.
16 SHP75-10-STP60-10-IA-xx-19
Danger to life due to electric shock when live
components or DC cables are touched
When exposed to light, the PV modules generate
high DC voltage which is present in the DC cables.
Touching live DC cables results in death or lethal
injuries due to electric shock.
• Do not touch non-insulated parts or cables.
• Disconnect the inverter from voltage sources
and make sure it cannot be reconnected before
working on the device.
• Wear suitable personal protective equipment
for all work on the product.
Danger to life due to electric shock when
touching live system components in case of a
ground fault
If a ground fault occurs, parts of the system may still be
live. Touching live parts and cables results in death or
lethal injuries due to electric shock.
• Disconnect the inverter from voltage sources and
make sure it cannot be reconnected before
working on the device.
• Touch the cables of the PV array on the insulation
only.
• Do not touch any parts of the substructure or
frame of the PV array.
• Do not connect PV strings with ground faults to the
inverter.
SMA Solar Technology AG
Installation Guide