Important Safety Instructions - SMA SUNNY BOY STORAGE 3.7 Notice

2 Safety
The product may only be operated with one of the energy meters approved by SMA Solar
Technology AG. The following energy meters are allowed to be used when operating this product:
• EMETER-20 (SMA Energy Meter)
• HM-20 (Sunny Home Manager 2.0)
The product may only be operated in battery-backup systems using an automatic transfer switching
device approved by SMA Solar Technology AG. You are not allowed to build automatic transfer
switching devices for operation with this product by yourself on the basis of a circuit diagram.
The following automatic transfer switching devices are allowed to be used when operating this
product:
• 10012856_V1.4 (3PH automatic transfer switching device for SMA Sunny Boy Storage) from
enwitec electronic GmbH & Co.KG
• For Italy only: 10013490_V1.0 (1PH Battery Backup-Distribution for 1 x Sunny Boy Storage)
from enwitec electronic GmbH & Co.KG
• For Italy only: 10013491_V1.0 (3PH automatic transfer switching device for SMA
Sunny Boy Storage) from enwitec electronic GmbH & Co.KG
• For Australia only: SBS-ABU-63.1-AU-10 (Automatic Backup Unit) from SMA Solar
Technology AG
Use SMA products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and directives. Any
other application may cause personal injury or property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express
written permission of SMA Solar Technology AG. Unauthorized alterations will void guarantee and
warranty claims and in most cases terminate the operating license. SMA Solar Technology AG
shall not be held liable for any damage caused by such changes.
Any use of the product other than that described in the Intended Use section does not qualify as the
intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace and is not intended to replace any local, state, provincial, federal
or national laws, regulations or codes applicable to the installation, electrical safety and use of the
product. SMA Solar Technology AG assumes no responsibility for the compliance or non-
compliance with such laws or codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
2.2

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
This section contains safety information that must be observed at all times when working.
The product has been designed and tested in accordance with international safety requirements. As
with all electrical or electronical devices, there are residual risks despite careful construction. To
prevent personal injury and property damage and to ensure long-term operation of the product,
read this section carefully and observe all safety information at all times.
6 SBSxx-10-IS-xx-18
SMA Solar Technology AG
Quick Reference Guide