Güde BL 560 BS Mode D'emploi page 13

4. Cutting (side ejection)
5. Hewed long grass lies down in the strips. Loose screw
(Fig. 1/15), pull part of side ejection out and then screw.
(Fig. 1/15) tighten again (Fig. 5)
Changeover to mulching
1. Assembly and disassembly of accessories must always
take place when the engine is switched off.
2. Remove the grass catcher, insert the mulching wedge to
the ejection channel and lock the mulching wedge (1) point it
against two outlets (2) in the bottom part and ensure it with a
self-securing hook (3).
3. Please make sure the mulching wedge is mounted firmly
after the changeover.
4. Attention!!! Use original equipment from the producer
only.
5. Disassembly
Press with thumb in the middle (3) then release and deflect
the mulching wedge downwards.
Attention!!!
If the mower is blocked during mulching reduce the
travelling speed so that the knife could continue in
grinding the grass and spread it on the lawn. Never
remove the gathered grass with your hands.
DRIVE CONTROL
The self-propelling travel is controlled as follows: Press the
operation lever (lever for automatic stopping) (12) towards the
handle and simultaneously press the drive lever towards the
handle (13).
The forward movement is stopped by releasing the drive lever
(13).
CUTTING HEIGHT ADJUSTMENT
Depending on the cutting height required it is necessary to
adjust the height of wheels. Adjust the height with the lever (8)
as you wish. The middle position is most suitable at most
mowers.
ADD OIL BEFORE STARTING
The oil level needs to be checked before each use. Fill up oil
as needed (500ml SAE30 engine oil).
FUEL ADDING (unleaded petrol)
• The fuel is added through the filling hole in the tank.
Pay attention not to spill the petrol. Use common
clean unleaded petrol. Do not mix the petrol with oil.
Always buy only reasonable volume of petrol so that
you could consume it within 30 days.
WARNING: Wipe any spilled oil or petrol. Do not
store, pour, use near open fire.
FUEL TANK CAP
VERSCHLUSS DES
KRAFTSTOFFTANKS
WARNING: Alcohol-enriched fuels (gasohol) or fuels with
ethyl alcohol or methanol mixtures may attract humidity and
subsequent acid formation. The clean petrol may as a result
of long storage damage the engine fuel system. If you want
to prevent engine problems you should empty the fuel
system before storing for more than 30 days. Empty the fuel
tank, start the engine and let it run until the fuel system and
carburettor are empty. Add fresh fuel each season. See the
storing instructions, too. Never pour cleaners to the fuel tank
to clean the engine or carburettor. By doing so, you could
cause irreparable engine damage.
ENGINE STARTING
At starting first make sure the spark plug is in its place and
there is sufficient amount of oil and petrol in the device.
CAUTION: The engine may smoke at first starting due
to protective oil film on the inner engine surface.
Consider this as normal.
Press the operation lever (automatic switching off
1.
lever) (8) to the mobile handle (1).
With the operation lever (automatic switching off lever)
2.
(8) pulled in slowly pull out the starting cord (6), when
you feel slight resistance strongly pull in the starter until
the engine is started.
13
Picture for engine starting