Stihl FSA 135 R Notice D'emploi page 50

English
21 Specifications
21.1 STIHL FSA 135 R Brushcutters
– Permitted batteries:
– STIHL AP
– STIHL AR
– Weight without battery, cutting tool and deflec‐
tor: 4.6 kg
– Length without cutting tool: 1885 mm
– Degree of electrical protection: IPX4 (protec‐
tion against splash water from any direction)
For runtime, see www.stihl.com/battery-life.
21.2 STIHL AP battery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
®
– Bluetooth radio interface (only for batteries
with ):
– Data connection: Bluetooth
mobile appliance must be compatible with
®
Bluetooth Low Energy 5.0 and support
Generic Access Profile (GAP).
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
– Mobile appliance operating system require‐
ments: Android or iOS (current version or
higher)
21.3 Temperature limits
WARNING
■ The battery is not protected against all ambi‐
ent conditions. If the battery is exposed to cer‐
tain environmental conditions, it may catch fire
or explode. This may result in serious injury to
people and damage to property.
► Do not charge the battery below -20°C or
above 50°C.
► Do not use the brushcutter or battery below
-20°C or above 50°C.
► Do not store the brushcutter or battery
below -20°C or above +70°C.
50
®
5.1. The
21.4 Recommended temperature
ranges
For optimum performance of the brushcutter and
battery, note the following temperature ranges:
– Charging: 5°C to 40°C
– Use: - 10 °C to + 40 °C
– Storage: - 20 °C to + 50 °C
If the battery is charged, used or stored outside
the recommended temperature ranges, perform‐
ance may be restricted.
If the battery is wet or moist, allow the battery to
dry for at least 48 h between 15°C and 50°C and
with less than 70% humidity. Higher humidity
may extend the drying time.
21.5 Sound and vibration values
The K value for the sound pressure level is
2 dB(A). The K value for the sound power level is
2 dB(A). The K-value for vibration level is 2 m/s².
STIHL recommends wearing hearing protection.
Using with a mowing head except PolyCut 28-2
– Sound pressure level L
ance with IEC 62841-4-4: 80 dB(A)
– Sound power level L
ance with IEC 62841-4-4: 92 dB(A)
– Vibration value a
hv
with IEC 62841-4-4
– Control handle: 1.8 m/s²
– Left handle: 3.7 m/s²
Use with a PolyCut 28-2 mowing head
– Sound pressure level L
ance with IEC 62841-4-4: 84 dB(A)
– Sound power level L
ance with IEC 62841-4-4: 97 dB(A)
– Vibration value a
hv
with IEC 62841-4-4
– Control handle: 1.8 m/s²
– Left handle: 3.7 m/s²
Use with a metal cutting attachment
– Sound pressure level L
ance with IEC 62841-4-4: 80 dB(A)
– Sound power level L
ance with IEC 62841-4-4: 92 dB(A)
– Vibration value a
hv
with IEC 62841-4-4
– Control handle: 2.9 m/s²
– Left handle: 2.9 m/s²
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
21 Specifications
measured in accord‐
pA
measured in accord‐
wA
measured in accordance
measured in accord‐
pA
measured in accord‐
wA
measured in accordance
measured in accord‐
pA
measured in accord‐
wA
measured in accordance
0458-662-9602-A