Stihl FSA 135 R Notice D'emploi page 41

8 Assembling the Trimmer
7.2 Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
8 Assembling the Trimmer
8.1 Mounting the Loop Handle
► Switch off the brushcutter and remove the bat‐
tery.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
8.2 Mounting the Barrier Bar
► Switch off the brushcutter and remove the bat‐
tery.
1
2
► Insert the nuts (2) in the barrier bar (1) so that
the holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (5) and
barrier bar (4) on the shaft (6).
► Press the clamp (7) against the shaft (6).
► Insert screws (8) and tighten.
0458-662-9602-A
®
®
radio interface:
symbol
3
4
5
3 4
5
6
7
8
8.3 Mounting and Removing the
Deflector
8.3.1 Mounting the guard
► Switch off the brushcutter and remove the bat‐
tery.
2
► Push the deflector (1) into the guides on the
gear housing up to the limit stop.
► Insert the screws (2) and tighten them firmly.
8.3.2 Removing the Deflector
► Switch off the brushcutter and remove the bat‐
tery.
2
► Unscrew the screws (2).
► Pull off the deflector (1).
8.4 Fitting and Removing the Skirt
8.4.1 Fitting the Skirt
► Switch off the brushcutter and remove the bat‐
tery.
1
2
► Slide the guide slot in the skirt (2) onto the uni‐
versal deflector (1) – it must snap into position.
► Push the line limiting blade (3) into the slot in
the skirt (2).
► Insert and tighten down the screw (4) firmly.
English
1
1
3
4
41