Stihl FSA 135 R Notice D'emploi page 42

English
8.4.2 Removing the Skirt
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin (2) into the hole in the skirt
(1).
► Remove the skirt (1) with the stop pin (2).
The line limiting blade (1) can be left on the skirt.
8.5 Mounting and Removing the
Mowing Head
8.5.1 Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise by hand.
► Insert the stop pin (4) in the bore up to the limit
stop and hold it depressed.
► Turn the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft (3) is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
8.5.2 Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin in the bore up to the limit
stop and hold it depressed.
► Rotate the mowing head until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
42
2
1
1
2
3
4
4
► Remove the thrust plate.
► Remove the stop pin.
8.6 Removing and Installing Metal
Cutting Attachment
8.6.1 Mounting the Metal Cutting Attach‐
ment
► Switch off the brushcutter and remove the bat‐
tery.
► Place the thrust plate (5) on the shaft (6) so
1
that its smaller diameter faces up.
► Place the metal cutting attachment (4) on the
thrust plate (5). If you are fitting a circular saw
blade or a grass cutting blade with more than
4 cutting edges: Its cutting edges must face in
the same direction as the arrow on the deflec‐
tor.
► Place the thrust washer (3) on the metal cut‐
ting attachment (4) so that its raised side faces
up.
► Place the rider plate (2) on the thrust washer
(3) so that its closed side faces up.
► Insert the stop pin (7) in the bore up to the limit
stop and hold it depressed.
► Rotate the metal cutting attachment (4) coun‐
terclockwise until the stop pin (7) engages in
position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it
down firmly.
► Remove the stop pin (7).
8.6.2 Removing the metal cutting attach‐
ment
► Switch off the brushcutter and remove the bat‐
tery.
8 Assembling the Trimmer
1
2
3
4
5
6
7
0458-662-9602-A