Dimplex XLF60 Manuel De L'utilisateur page 7

Fireplace Installation
CAUTION: Ensure installation
does not allow fireplace to be
in direct contact with building
vapor barrier or insulation and
meets all local building code.
!
NOTE: A dedicated, properly
fused 15 Amp circuit is required,
rated for the appropriate voltage
(120V, 240V).
WARNING: Construction
and wiring must comply with
local building codes and other
applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
WARNING: To reduce the risk
of fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING: To reduce the
risk of fire, do not store
or use gasoline or other
flammable vapors or liquids
in the vicinity of the heater.
1. Select a location that is
not susceptible to moisture
and is away from drapes,
furniture and high traffic.
2. Unpack the fireplace and
hardware from the box.
!
NOTE: Leave the front glass
and partially reflective glass,
safely, in the box until the time
you are ready to install it.
3. Store the fireplace in a safe, dry
and dust free location until you
are ready to install the fireplace.
Framing
CAUTION: Two people will be
required for various steps of this
procedure.
This design of this unit allows
three options for installation:
partial recess, flush mounted or
sub-surface mounted.
Figure 2
2" x 6"
5 1/2" (14.0 cm)
2" x 4"
3 1/2" (9.0 cm)
XLF60: 60 5/8" (154.0 cm)
16"
(40.6 cm)
7