Dimplex XLF60 Manuel De L'utilisateur page 20

Operation (continued)
Disable Heat
If desired, depending on the
season, the heater on the unit can
be disabled. The function of the
remaining controls will continue
to function as outlined in this
manual.
Pressing the
on the unit at the same time and
holding for 2 seconds will disable
and enable the heater.
! NOTE: When the heater has
been disabled and any of the
heat related functions are used,
the Display will indicate "---".
If the Permanent Heat Disable
has been activated by removing
the jumper on the main PCB, the
display will indicate "H--".
H. Color Themes
Different presets of lighting color
combinations are available in
the unit.
Changed by repeatedly
pressing the corresponding
button on the remote or the
unit.
20
and buttons
• Cycles through the different
preset light settings of the
unit, this includes different
combinations of colors of the
flame base and media lighting.
! NOTE: Two of the themes in
the cycle are a prism where the
unit cycles through a variety of
colors. Pressing the
the cycling and holds the unit on
the preferred color, indicated by
a solid circle. When the unit is
on prism, and is cycling through
the colors, a rotating circle will
be displayed.
I. Brightness
Changes the Brightness of the
lights in the unit.
Adjusted by repeatedly pressing
the corresponding button on the
remote or the unit.
• Indicated by the second digit
on the Display changing to
show: "H" (high), and "L" (low).
Pressing the T- and Brightness
buttons at the same time and
holding them for 2 seconds will lock
( will be displayed) or unlock
LOC
( will be displayed) the manual
U L
controls on the fireplace.
stops
www.dimplex.com