Aosom 370-149V80 Instructions De Montage page 11

Hole on the gear box
Cut off the plastic ties on the gear boxes. Remove all the parts
from the rear axle.
1. Insert the rear axle through the hole in the vehicl body, when inserting it half way,
lift the another gear box so that the rear axle can go through it and protrude out.
Make sure that the rear axle is centered with left and right ends exposed the same
distance outside of the ride-on toy body.
5
6
2. Slide the rear wheel onto the rear axle .
3. Slide the Ø12 washer onto the rear axle.
4. Tighten a lock nut to the end of the rear axle with a spanner.
Repeat the 2-4 steps for the other rear wheel.
HINT: An extra spanner has been provided to hold the Lock Nut on the other side of the rear
axle while tightening the Lock Nut on the other side. DO NOT over tighten.
5. Insert a split pin into the hole on the each end of the rear axle. Bend the ends of split pins
back using a long nose pliers (not included).
6. "Snap" a hubcap to each rear wheel.
Attach the Rear Wheels │ 7
1
3
4
Rear Bottom View
2