Aosom 370-149V80 Instructions De Montage page 10

1
Front Bottom View
4
Cut off the plastic tie on the front axle with scissors.
1,2. Adjust the front axle plate so that the axle is in the correct position as shown
(8-1);
3. Slide a Ø12 washer onto the steering column from the bent end.
4. Insert the split pin into the hole on the bent end of the steering column. Bend the
ends of split pin back using a long nose pliers (not included).
5. Remove the M6x20 machine screw, Ø6 washer and Ø6 lock nut from the front axle
linkage. Reinsert the M6x20 machine screw through the hole on the front axle
linkage, the Ø6 washer, the hole on the front axle plate, and fasten the Ø6 lock nut
to the opposite end of the screw.
Reset the Front axle │ 6
1
8-2
3
Steering column
Split pin
Ø12 washer
Front axle Front axle
plate plate
8-1
2
8-3
M6X20 machine
screw
Front axle
linkage
Ø6 washer
Ø6 lock nut