CAME OPS Serie Manuel D'installation, D'utilisation Et D'entretien page 44

Saving the trimmer value
Use the trimmer to adjust the automatic closing time (A.C.T.), the slow- down speed (SP.RAL.) and the
sensitivity (SENS.).
To save the values:
select the DIP switches as shown and press the P1 key on the control board. The LED stays on and the
buzzer sounds off for one second.
Warning! If the data is not saved, the adjustments will be lost.
Transmitter activated partial opening
Select the DIP switches as shown and press the P1 key on the control board. The red LED
blinks. Within 10 seconds, press a key on the transmitter you want to save.
Once the transmitter is saved, the red LED turns on the buzzer sounds off for 1 s.
If the transmitter has previously been saved, the LED blinks quickly and the buzzer sounds
off 4 times.
Transmitter activated open only
Select the DIP switches as shown and press the P1 key on the control board. The red LED
blinks. Within 10 seconds, press a key on the transmitter you want to save.
When memorization is successful, the red LED stays on and the buzzer sounds off for 1 s.
If the transmitter has previously been saved, the LED blinks quickly and the buzzer sounds
off 4 times.
Transmitter activated OPEN-CLOSE-INVERT
Select the DIP switches as shown and press the P1 key on the control board. The red LED
blinks. Within 10 seconds, press a key on the transmitter you want to save.
Once the transmitter is saved, the red LED stays lit and the buzzer sounds off for 1 s.
If the transmitter has previously been saved, the LED blinks quickly and the buzzer sounds
off 4 times.
Transmitter activated OPEN-STOP-CLOSE-STOP
Select the DIP switches as shown and press the P1 key on the control board. The red LED
blinks. Within 10 seconds, press a key on the transmitter you want to save.
Once the transmitter is saved, the red LED stays lit and the buzzer sounds off for 1 s.
If the transmitter has previously been saved, the LED blinks quickly and the buzzer sounds
off 4 times.
Deleting all users
Select the DIP switches as shown and press the P1 key on the control card, for 5 seconds.
Once deletion is complete, the red LED stays lit and the buzzer sounds off for 1 s.
Resetting parameters
Select the DIP switches as shown and press the P1 key on the control board. The LED blinks and buzzer
sounds off 2 times.
With this feature, users are not deleted.