Publicité
Standby mode
This mode is only available in case of using a full network (Link, Cubo,
Vigo and Dongle). The Standby mode has to be enabled in Switch-It®
Vigo Toolbox, under the Device Order menu.
The mode itself is only accessible if the Dongle has been removed or it's
out of range. Long-pressing the Headrest Sensor will switch from Drive
mode to Standby mode in this case. This mode has no active state.
The purpose of this mode is to act as filler, in case the user doesn't need
the Drive mode (not even in its passive state), but doesn't have a Dongle
nearby to switch to Mouse mode as a stand in.
Switching between available functions
If the user has a system of at least the following connected devices: Link,
Cubo, Vigo and Dongle (i.e. the potential to use 'drive mode' or 'mouse
mode'), then they can switch between the modes these devices provide
(in this case driving and mousing) by long-pressing (1-5 seconds) the
Headrest Sensor.
The Cubo's screen will show the current mode (e.g.: LINK drive,
MOUSE).
79
Publicité
