Publicité
On the Link there are two connector interfaces. One of which is an
integrated cable with a D-type connector on it to control the Omni
(referred to as Omni cable) and another square shaped interface to
connect the Cubo cable (referred to as Data cable).
Omni Port-1 D-type connector
The preferred SID port, if there is only one input device connected to the
Omni is Port 1, as shown in the picture below. In case of using a PGDT
IOM there is only one INPUT port where the D-type connector can be
connected:
The two interfaces of the Link
(on the left, the square-shaped
data connector)
46
Publicité
