Publicité
Please make sure that the wiring meets the following criteria:
● The Link must be properly connected to PGDT Omni or IOM or
Quantum Q-Logic 3 via an Enhanced Display or a SCIM Module.
● The Link D-type connector connecting to the wheelchair
● Cable to the wheelchair must be tied to the frame to avoid
● Cable placement has to be designed so that cables are
● The analog connector should be connected to Omni Port-
controller must be secured with screws.
accidental tearing or crushing by the movement of
actuators.
protected during accidental crashes if the wheelchair hits
an obstacle.
1 or IOM INPUT only.
48
Publicité
